Free, independent repair guides
HeatCoolFix

Window AC Making Noise: What Is Normal and What Is Not

Window AC Making Noise: What Is Normal and What Is Not
Short answer

Most window unit noises are meant to happen. Frigidaire and GE list them between them: a high pitched chatter from the compressor, rushing air, a gurgle or hiss of refrigerant, a click as the compressor cycles, and pinging or sloshing as a ring on the fan throws water onto the coil. A rattle is usually the install, a loose grille or louver, or a dirty filter.

A window unit has a whole air conditioner in one box sitting in your window: the compressor, both fans and both coils. So it is louder than central air, and much of what people hear is meant to happen.

Frigidaire’s own answer to why a room air conditioner makes noise lists five sounds and calls every one of them normal. This page sorts the normal sounds from the ones you can fix, using what Frigidaire, GE and LG say in their own help pages.

Before you start

What to carry: a torch and a screwdriver. Ten minutes.

Gas or electric? Electric. A window unit plugs into the wall, so unplug it before you touch the grille, the filter or anything else.

Notice when it happens. At start up, all the time it runs, or only while it is cooling hard on a humid day. Each points somewhere different.

Two things before you go looking. Never drill the base. Frigidaire says not to drill holes in the base pan to get rid of the normal water sounds, and that doing so voids the warranty.

A noise with a burning smell. Unplug it and do not use it again until somebody has looked inside: what each window AC smell means.

The sounds that are normal

SIX SOUNDS THE MAKERS CALL NORMAL High pitched chatter the compressor, cooling Rushing air the fan, at the front Gurgle or hiss refrigerant in the coil A click the compressor cycling Pinging or sloshing water on the fan ring Hum at start up the compressor starting
Six sounds Frigidaire or GE treat as normal operation. If yours is on this list, the unit is working.
Check 1

Match the sound to the list

A high pitched chatter. Frigidaire says today’s high efficiency compressors may chatter during the cooling cycle.

Rushing air. Frigidaire says you may hear air being moved by the fan at the front of the unit. GE says air noise is heard whenever the fan runs.

A gurgle or hiss. Frigidaire says this is refrigerant passing through the evaporator during normal operation.

A click, or a metallic sound. GE says it is the compressor cycling on and off, and calls it normal.

A hum or roar at start up. GE says a slight hum or roar from the compressor as it cycles on and off means the unit is working normally.

A beep when you plug it in. GE says that is normal when power is connected.

Pinging and sloshing: the water ring

WHERE THE PINGING COMES FROM The cold coil water condenses on it and runs to the pan The slinger ring on the rear fan picks the water up The hot coil the water is thrown onto it to shed heat The pinging and sloshing That is the water hitting the coil. GE and Frigidaire both call it normal, and Frigidaire says never to drill the base pan to stop it.
GE's explanation of the pinging: water from the cold coil, picked up by a ring on the fan and thrown onto the hot coil.
Check 2

Know about the slinger ring

What it is. GE says all room air conditioners have a slinger ring around the rear fan blade. It picks water up off the bottom of the pan and throws it against the condenser coil, which helps the unit run more efficiently.

The sound. GE says it is normal to hear a pinging or sloshing sound as the fan blade moves through the water. Frigidaire says droplets of water hitting the condenser cause pinging or swishing.

Water dripping outside. GE says that on very hot and humid days, excess water may drip on the outdoor side, and calls that normal. The unit must be level or tilted slightly to the outside.

A code for a full tray. On a Frigidaire, P1 means the bottom tray is full: what the window AC codes mean.

Rattles and vibration

Check 3Free, fifteen minutes

Check what GE and LG list

The front grille. GE says it may be loose or broken. Remove it and check it, then refit it following the owner’s manual.

The louvers. GE says movable louvers can come loose or break. On some models they snap back into place.

The filter and the outside. GE says to clean the air filter and clear debris and dirt from the outside of the unit. LG says a dusty filter makes the noise louder.

The installation. GE says a poor install can make the window sill vibrate, and to check the side panels are screwed to the window frame and sill. LG says the support bracket must be secure and level, or the unit is noisy when the motor or compressor runs.

The window itself. Frigidaire says the unit may vibrate because of poor wall or window construction as well as an incorrect install.

Portable units

Check 4

The portable's own sounds

Water dripping sounds at first. LG says moving louvers can make water dripping sounds early on, and that the noise drops as the unit keeps running. Check the louver area for leftover protective film or anything stuck in it.

Sloshing while it runs. Many portables are built to evaporate their own condensate, so water moving inside is part of the design. LG says its units are designed to let condensate evaporate.

A gurgling hose. A dip in the exhaust hose collects water: a portable that is not cooling.

When a noise is a fault

Check 5A repair, or a new unit

Know when to stop

Loud humming with no fan and no cooling. Current is going into a part that is not turning. Unplug it: a window unit that is not cooling.

Grinding or scraping. A fan is touching something. Unplug it before you look.

Check the warranty first. GE says its portable units and most of its window units are not serviceable and have no repair parts. Read the warranty before paying for a diagnosis.

Central air instead. A split system’s noises come from two places: central AC noises.

Questions people ask

Why does my window AC make a pinging noise?

A ring on the rear fan picks up water from the base pan and throws it at the outdoor coil. GE and Frigidaire both say the pinging or sloshing is normal.

Is it normal for a window AC to gurgle?

Yes. Frigidaire says a gurgle or hiss is refrigerant passing through the evaporator during normal operation.

Why does my window AC rattle?

GE’s list: a loose or broken front grille, loose louvers, a dirty filter or dirt outside, or a poor install making the sill vibrate. LG adds a loose or unlevel support bracket.

Why does my window AC click?

GE says a click or metallic sound is the compressor cycling on and off, and that it is normal.

Can I drill a hole to stop the water noise?

No. Frigidaire says not to drill holes in the base pan to get rid of the normal sounds, because it voids the warranty. The water is part of how the unit cools its coil.

Why is my new window AC so loud?

Check the install first. GE says the side panels must be screwed to the frame and sill, and LG says the support bracket must be secure and level.

Sources: Frigidaire support "Room Air Conditioner - Noises" and "Why is my room air conditioner making noise?", GE Appliances "Air Conditioner - Normal Noises", "Rattling Noise", "Slinger Ring", "Water Sounds" and "Noise On Start Up", LG USA "Troubleshooting Noises" and its portable noise article