Free, independent repair guides
HeatCoolFix

Lennox Heat Pump Not Heating: XP21 Owner Checks

Lennox Heat Pump Not Heating: XP21 Owner Checks
Short answer

For a Lennox XP21 not heating after power was interrupted for several hours or more, its owner instructions specify temporary Emergency Heat and a six hour compressor crankcase warmup before returning to Heat. At other times, check settings, accessible airflow and whether a defrost cycle finishes. This restart rule is specific to the cited XP21 manual.

A Lennox heat pump not heating after a long power cut needs its restart instructions checked first. In the XP21 homeowner section, Lennox gives a specific procedure using temporary auxiliary heat while the compressor crankcase warms up.

If there was no extended outage, start with the settings, airflow and defrost checks below. This page uses Lennox’s XP21 instructions 507217-02, dated August 2019. An XP25, SL25XPV or other Lennox model needs its own restart procedure and fault chart.

Before you start

What to carry: a torch, the thermostat user manual and your installation paperwork. Note when power went off and returned, and copy the outdoor model from a safely accessible label or service record.

Gas or electric? Lennox describes the XP21 as an outdoor heat pump paired with an approved indoor air handler or coil. Identify any separate gas furnace as well. Its controls and heating fault need recording separately from the outdoor unit.

Renting? Tell maintenance whether the outage affected the whole home or only the heating equipment. Include the selected thermostat mode and the room temperature.

Power off for maintenance; covers in place for operation.
In its XP21 homeowner section, Lennox requires power off at the disconnect before service or maintenance. Its electrical warning requires all remote supplies disconnected before an access panel is opened and notes that multiple supplies may be present.

Keep outdoor service access closed. Lennox puts wiring, voltage, capacitor, contactor and refrigerant checks in its professional maintenance section. For any permitted user maintenance, restore the filter and all access panels before operation, as Lennox requires.

After an extended power outage

Check 1Temporary installed backup heat and the specified warmup period

Use the XP21 restart instruction for a long interruption

Lennox’s XP21 owner instructions address power interrupted for several hours or more. They say to select Emergency Heat for temporary heating, then allow a six hour compressor crankcase warmup before switching the thermostat back to Heat. The crankcase heater needs electrical power for that warmup; time spent with the supply still off does not warm it.

In this mode, Lennox says auxiliary heat supplies the heating demand and heat pump operation is locked out. A quiet outdoor unit while Emergency Heat is selected is therefore consistent with that setting.

XP21 AFTER AN EXTENDED POWER CUT APower interrupted for several hoursUse this model's extended outage procedure. BEmergency Heat and powered warmupInstalled auxiliary heat serves the house. CAfter the six hour crankcase warmupReturn to Heat using the thermostat guide.

Lennox's XP21 extended outage instructions: A, identify the long interruption; B, use installed auxiliary heat in Emergency Heat during the powered crankcase warmup; C, return to Heat after the specified six hour warmup. This is not a restart rule for every Lennox model.

Use the thermostat’s user instructions for the mode change. If your installed system cannot provide that mode or its auxiliary heat does not work, contact the servicing dealer for the appropriate recovery procedure. Do not force the compressor on by jumping terminals.

When the system does not start

Check 2Accessible settings and observations before a service visit

Work through Lennox's owner checklist

Lennox’s XP21 pre-service list starts with correct room thermostat settings, electrical disconnects On, blown fuses or tripped breakers, access panels in place and a clean air filter. Its separate thermostat section sends you to the thermostat’s own homeowner manual for operating instructions.

Read the mode and temperature setting first. Note any alert and whether it appeared before or after the power interruption. Check normal, safely accessible power switches visually, without opening an electrical enclosure or testing a fuse.

If a breaker is tripped, report the affected circuit. Repeated attempts to restore power are not a diagnosis. With a message at an iComfort control, use our Lennox thermostat alert guide; the XP25 heat pump code guide is separately scoped to that outdoor unit.

When it runs but the warmth is interrupted

Check 3An observation of the cycle and the heating afterward

Look for the end of the XP21 defrost cycle

Lennox’s XP21 homeowner information describes winter frost and a defrost cycle lasting 5 to 15 minutes. It says steam rising from the outdoor unit during that cycle is normal, and the thermostat may engage auxiliary heat to satisfy demand.

Lennox says the unit returns to normal operation at the end of defrost. Watch for that result from outside the closed equipment. If heating does not resume after defrost or ice still blocks the unit, call for service.

Do not use that owner description to change a timer or force a test. The broader heat pump winter icing guide explains how frost differs from an ice blockage.

Check 4Specified filter care and loose debris removal; professional work inside

Clear the owner air path and leave internal checks to service

Lennox allows XP21 owners to check the indoor filter monthly and clean or replace it as needed. It says disposable replacements should match the original type and size. Have the dealer identify the user filter location if you do not already know it; do not search inside unfamiliar service compartments.

For the outdoor area, Lennox lists grass clippings, leaves and paper as obstructions to remove, and says to keep shrubbery away. Its winter instruction is to keep snow below the louvered panels. Follow the maintenance power isolation rule above before doing that work.

XP21 OWNER MAINTENANCE POINTS AIdentified indoor filterSame type and size for a disposable filter BOutdoor airflowKeep snow below the louvered panels.Remove loose leaves, paper and clippings.

Owner observations from Lennox's XP21 guidance: A, the identified indoor filter location; B, loose outdoor obstructions and snow below the louvered panels. Internal base pan, electrical and refrigerant checks are assigned to professional maintenance.

Lennox assigns base pan drain inspection, wiring inspection and electrical measurements to professional maintenance.

What each one takes

Finding Work involved
XP21 after a long power interruption The manual’s temporary backup heat and powered crankcase warmup
Unexpected thermostat or normal power switch setting The user controls and the system records
Dirty identified filter or loose outdoor debris Owner maintenance with power isolation
Defrost does not restore heating Professional evaluation of the cycle and outdoor condition
Stopped equipment or internal maintenance needed A service visit with the model and observations ready

Questions people ask

Where is the XP21 manual used here?

Lennox hosts XP21 instructions 507217-02. The homeowner sections contain the outage procedure and pre-service checklist.

Does Emergency Heat mean the outdoor compressor is running?

In the cited XP21 instructions, Emergency Heat locks heat pump operation out and uses auxiliary heat. Tell service which mode was selected when you observed the equipment.

Should heat pump air feel as hot as furnace air?

Lennox describes the XP21 as delivering larger amounts of warm air, compared with a furnace’s smaller amounts of hotter air. The general heating guide covers checking the delivered heat.

Can I run it with the filter out while testing?

Lennox requires the filter and all access panels in place whenever the unit operates. Refit them before restoring operation.

What if I have another Lennox heat pump?

Use its model-specific owner instructions, particularly after a power outage. Do not apply the XP21 procedure or its defrost description to an unidentified outdoor unit.

The other heat pump guides: cold weather heating, the outdoor unit staying off and model-specific reset checks.

Sources: Lennox XP21 Installation Instructions 507217-02, August 2019, safety warnings and Homeowner Information, Homeowner Maintenance, Pre-Service Check, Extended Power Outage and Professional Maintenance sections, pages 21 to 23